- Ajinomoto Co., Inc. v. Abtis Co., Ltd.No claims unpatentablePTAB · Aug 3, 2026 · IPR2025-00283 · APJ Lilan Ren · IPR · Final written decision
The Board cancelled claim 11 and granted substitute claims 14–16, finding Petitioner had not shown those claims unpatentable on any asserted ground.
RulingsFinal written decision- PTAB / AIA Trials › Motions to amend / substitute claimsMotion to amend, grantedGranted
“must determine whether the motion to amend meets the statutory and regulatory requirements set forth in 35 U.S.C. § 316(d) and 37 C.F.R. § 42.121. Lectrosonics, Paper 15 at 4. In that regard, Patent Owner bears the burden of persuasion to show that: (1) the amendment proposes a reasonable number of substitute claims; (2) the amendment responds to a ground of unpatentability involved in the trial; (3) the amendment does not seek to enlarge the scope of the claims of the patent or introduce new subject matter;” slip op. at 9
- ExcludeMotion to exclude, deniedDenied
“In this case, Patent Owner’s expert “Dr. Zhou signed the second declaration, stood behind its contents, and was available for cross-examination.” Paper 35, 4. Petitioner does not dispute this statement. Paper 39, 1. Petitioner does not identify any specific undue prejudice caused by Exhibit 2008. For example, Petitioner argues that “the failure to impress upon a witness that a statement is under oath goes to the heart of its reliability as evidence” and that “as the Board has recognized, hearsay is inherently unreliable” without specifying what statement in Exhibit 2008 lacks reliability. Paper 39, 4. Because Petitioner does not provide specific evidence of undue prejudice, we find Petitioner has suffered no such undue prejudice in this case. See Liquidia, 2021 WL 4860773 at *25. We therefore deny Petitioner’s Motion to Exclude on the basis of lack of authenticity. With regard to the assertion that Exhibit 2008 is hearsay, Petitioner objects to the exhibit because the testimony is based “on other informal and unpublished documents that are hearsay under FRE 802.” Paper 29, 1. Petitioner does not specify what such “informal and unpublished documents” are. See id. Federal Rule of Evidence 703 expressly states, “[a]n expert may base an opinion on fact or data in the case that the expert has been made aware of or personally observed.” The facts or data “need not be deny Petitioner’s Motion to Exclude on the basis of hearsay.” slip op. at 50
- Disclosure Requirements (§112) › Written description (Ariad)Written description adequateNot shown unpatentable
“Petitioner’s argument is unpersuasive. Paragraph 59 of the ’503 application describes formula 8-1 but does not support Petitioner’s argument that other unknown formulas may be included in the recited modified heavy chains. Ex. 2003 ¶ 59. Petitioner’s hypothesis that the recited heavy chains may (or may not) encompass unknown formulas is also inapposite to the written description inquiry before us — that is, whether the inventor was in possession of the subject matter recited in claims 14–16 based on the disclosure including formulas 8-1, 8-2, and 8-3. See PowerOasis, 522 F.3d at 1306.” slip op. at 14
- Disclosure Requirements (§112) › Enablement (Wands, Amgen full scope)EnabledNot shown unpatentable
“These arguments in the Sur-Reply are unpersuasive to show a lack of enablement first and foremost because the arguments do not specifically provide evidence showing that any purported experimentation is undue. See Sur-Reply 2–8 (asserting, but without providing evidence under any specific Wands factors, that the examples and guidance in the specification do not extend to the broad scope of all antibodies); see Wands, 858 F.2d at 737. We again emphasize that the analysis of undue experimentation does not necessarily require every Wands factor to be explicitly addressed but the analysis must be based on “weighing many factual considerations” depending on the nature of the invention and underlying art. Cephalon, Inc. v. Watson Pharms., Inc., 707 F.3d 1330, 1336 (Fed. Cir. 2013). The assertion that the claim scope is broad alone does not suffice to show a lack of enablement based on the record before us. Moreover, as we note supra, Petitioner’s claim scope argument is based on the false premise that the scope of claims 14–16 is as broad as the claim term “antibody” without taking into account all other claim elements. For example, Petitioner does not disagree with Patent Owner’s statement that “[t]he ’675 Patent’s specification discloses the structural modification site, the chemistry used to modify that residue, and working examples demonstrating the modification” (Reply 2), but asserts only that “[t]he disclosure of SSFI that only binds to IgG1 Fc domains (SEQ ID NO:1) is . . . . inconsistent with the expansive scope of the claims.” Sur-Reply 5. Petitioner’s argument that the claims encompass proteins that lack a lysine reside at a 248 position improperly excludes from the claim language the “lysine residue at 248 position . . . [as] determined by the EU numbering system” that claims 14–16 require. As Dr. Zhou testifies, “each proposed lysine residue at position 248 (EU numbering) is covalently modified with a specific attachment with a terminal bio-orthogonal click-chemistry functional group. The specification describes targeted transfer of a chemical functional group to lysine 248” and when claims 14–16 are considered in their entirety, which includes all claim elements, “[a] POSA would understand the claim itself to limit the modified antibodies to those with lysine at position 248.” Ex. 2004 ¶ 48; Ex. 2008 ¶ 47. We also note that Patent Owner states “a POSA would understand that the phrase ‘one or more modified heavy chain’ encompasses antibodies within typical DAR distributions (i.e., fractional numbers) rather than requiring a distinct process for producing antibodies bearing modified heavy chains in exact integers.” Reply 2–3. Moreover, Patent Owner states that PepTalk Presentation demonstrates that “a POSA would understand antibody conjugation products to exist as mixtures rather than discrete whole number species” because PepTalk Presentation “presents DAR values as non-integer measurements, i.e. DARs of 1.8 and 1.9 reflecting such distributions.” Id. at 3 (citing Ex. 1007, 28). According to Patent Owner, “preparations having an average DAR of approximately 1.8 (commonly referred to in practice as ‘DAR2’) may reflect typical reaction distributions in which some antibodies contain two modified heavy chains while others contain fewer.” Id. at 3 (citing Ex. 2008 ¶ 46). Petitioner does not rebut these statements. See Sur-Reply 2–8. Based on the foregoing, the evidence before us does not show any” slip op. at 27
Patent outcomesUS 11,896,675 not shown unpatentable§ 102 anticipation§ 103 obviousness§ 112 disclosurecites Phillips · KSR · Graham · NautilusPatents in suitUS 11,896,675 - Shenzhen Tuozhu Technology Co., Ltd. v. Stratasys, Inc.No claims unpatentablePTAB · Jun 9, 2026 · IPR2025-00321 · APJ Christopher M Kaiser · IPR · Final written decision
The Board held claims 1, 2, 5–7, 9, 16, and 17 not unpatentable because the asserted combinations did not establish the required purge-tower teachings or prior-art status.
RulingsFinal written decision- Skill levelSkill level petitioner adoptedDecided for petitioner
“Petitioner contends that one of ordinary skill in the art “would have had (1) at least a bachelor’s degree in Mechanical Engineering, Computer Engineering, Chemical Engineering, Materials Science, or a related field, and (2) at least two years of research or industry experience in 3D printing or materials used for 3D printing.” Pet. 5 (citing Ex. 1003 ¶¶ 14–16). Petitioner also argues that “[a]dditional experience could substitute for a formal degree or formal training (and vice versa).” Id. Patent Owner proposes a slightly different level of skill, arguing that a person of ordinary skill in the art “would have had a bachelor’s degree in Mechanical Engineering, Computer Engineering, Chemical Engineering, Materials Science, or a comparable field and at least two years of experience related to 3D printing, with additional experience potentially being a substitute for a formal degree or training (and vice versa).” Prelim. Resp. 24. Neither party explains why the outcome of this case would be affected by the adoption of any of the proffered definitions of a person of ordinary skill in the art. We adopt Petitioner’s assessment of the level of ordinary skill in the art, as it appears consistent with the ’324 patent and the asserted prior art. See Okajima v. Bourdeau, 261 F.3d 1350, 1355 (Fed. Cir. 2001).” slip op. at 8
- Claim Construction › Intrinsic evidence (Phillips canons) › Plain and ordinary meaning to a POSITATerm construed board ownOther
“According to the ’713 patent, “[p]urge tower 24 itself may be . . . recycled or otherwise discarded as desired.” Ex. 1001, 8:27–28. This description provides some support for Patent Owner’s view, because a purge tower too intimately integrated with the part would be difficult or impossible to recycle or discard. This is further supported by the ’713 patent’s statement that “purge tower 24 may be printed at any suitable location on build substrate 44 (i.e., at any location in the x-y build plane not occupied by 3D part 20 or support structure 22).” Id. at 8:30–34. It also is supported by Dr. Hickner’s testimony that the ’713 patent “clearly shows . . . the 24 purge tower separated from the part” and that “the purge tower is a separate physical object.” Ex. 2016, 28:8–10, 64:1–9. On the other hand, there is evidence supporting Petitioner’s view that, as long as the purge tower is generally separate from the part and the support structure, it may still make contact with those portions of the print. As noted above, “purge tower 24 may be printed at any suitable location on build substrate 44 (i.e., at any location in the x-y build plane not occupied by 3D part 20 or support structure 22).” Ex. 1001, 8:30–34. This language does not exclude locations adjacent to or in contact with the part or the support structure. Thus, determine that a “purge tower,” as that term is used in the context of the ’713 patent, may not be an integrated portion of a printed part or support structure but need not be free of all contact with the printed part or support structure.” slip op. at 9
- BurdenNot shown unpatentable
“There is evidence of record to support both Petitioner’s view and Patent Owner’s view. On the record developed at trial, however, we cannot say that the preponderance of the evidence favors Petitioner, who bears the burden of proof. See 35 U.S.C. § 316(e). Accordingly, Petitioner has not shown by a preponderance of the evidence that KISSlicer teaches printing a layer of a purge tower each time the printer switches one extruder to the operating mode. Because proving the obviousness of claims 1 and 16 requires such a showing, Petitioner has not shown by a preponderance of the evidence that claims 1 and 16 would have been obvious over the combination of Priedeman and KISSlicer. 5. Analysis of Remaining Claims Claims 2, 6, 7, 9, and 17 all depend, directly or indirectly, from claim 1 or claim 16. Accordingly, they all include the limitations of either claim 1 or claim 16. Because, as discussed above, Petitioner has not shown that the combination of Priedeman and KISSlicer teaches or suggests all the limitations of claims 1 and 16, Petitioner also has not proven by a preponderance of the evidence that claims 2, 6, 7, 9, and 17 would have been obvious over that combination of references.” slip op. at 21
- Obviousness (§103) › Analogous artAnalogous artOther
“On the record developed at trial, we agree with Petitioner. According to several industry forum posts, people interested in three-dimensional printing located the website where KISSlicer was posted between February 2012 and April 2012. Ex. 1028, 1 (post discussing and directing others to KISSlicer on April 11, 2012); Ex. 1031, 1 (two posts discussing KISSlicer on March 16, 2012, and March 21, 2012); Ex. 1032, 1 (two posts discussing KISSlicer on February 11, 2012, and February 14, 2012). Thus, not only was it possible for people of ordinary skill in the art to locate KISSlicer; people of ordinary skill in the art actually did locate it. Accordingly, Petitioner has shown by a preponderance of the evidence that KISSlicer was publicly accessible.” slip op. at 19
Patent outcomesUS 9,421,713 not shown unpatentableClaim construction§ 102 anticipation§ 103 obviousnesscites Phillips · KSR · GrahamPatents in suitUS 9,421,713
Holdings, summaries, rulings, issues, outcomes, winners and claim constructions shown for a decision were generated by a large language model reading the opinion. They are a guide to the decision, not the decision. Confirm every one against the court's own text before relying on it. Outcomes read from the patent owner’s side. Party names are extracted from the decision and are missing on about 900 short Director denials and scans, which carry the trial number instead.